DOOR LEAF

• Solid materials door stile (internal frame) used for making doors.
• The optimal humidity rate is %12 consisted of the coniferous tree which was dried privately.
• After it was purified from the snags, it is combined with finger-jointed, destroyed the deformation, and increased the resistance.
• The size of the stiles’ section is 28*42
• There are air space grooves that have 6*3mm measures inside the stiles.
• There will be a double stile on the sub of the door leaf.
• Also there will be an extra stile for opening lock housing.
• The door leaf is made up of 6mm MDF covered by the veneer. The lock housing is drilled for a 40mm oval lock. Hinge housing and lock striker are drilled if there is a special request.
• There will be used honeycomb which has resin-based, 1,3 kg/cm2 resistance and comply with TSEK in the framework.
• General principles as mentioned above are the same for producing glazed doors. While the carcass process there will be a solid stile on the housing of glass opening that will be drilled in the middle of the door leaf.

DOOR FRAME

• All the door frames are made from 42mm sandwich panels (12mm MDF+18 mm solid wood + 12mm MDF)
• All the door frames are suitable for using regulated architraves and the architraves montage grooves, gasket grooves and rabbet will be drilled.
• The door surface will be cover with a veneer.
• The join of the door head will be 45 degrees. There will be a drill for the special screw.
• There will be drilling for gasket groove in the frame rabbet in order that the sound and heat insulation is provided.

MOLDINGS

• In accordance with details of adjustable moldings, they will be made up of MDF that has 12 mm thickness and 80 mm width.
• The surface of the moldings will be covered with a veneer.

VARNISH

• For top surface varnish, we use the best quality that belongs to respective companies.
• All of the materials are acrylic-based varnish and comply with environmental and human health and it includes.
• The fill and finishing varnishes used in production, have very-high resistance to scratch yellowing.

TESTS

1. All the interior doors are produced to TSE (TS 1905) standards.
2. The press doors are installed as a set (frame + door leaf) and they are tested in the bootstrap machines.
3. We rigidly and routinely test selected products with drilling methods and record the results. These include:
   • Horizontal resistance test
   • Vertical resistance – hanging test
   • Heavy/soft impact test
   • Light/hard impact test